...
- Set up the light stand with the legs as wide as possible for maximum stability.
- Place a sand bag on one or more legs for added stability and safety.
...
- Check each light for defects and check it has a current Curtin safety tag.
...
- Attach the light to the stand, open barn doors.
...
- The HMI Light is heavy it is recommended 2 people lift it onto the stand.
...
- Check the light and barn doors are securely fitted with no risk of falling.
...
- Check the light is safe distance from flammable objects such as ceiling, curtains or wall paper. As a general guide allow 1 meter above the light and 2 meters in front.
...
- Check the supplied Portable Power Block has a current Curtin safety tag.
...
- Plug the Portable Power Block directly into a wall socket.
...
- Check the test function of the Portable Power Block and reset the circuit breaker.
...
- Ensure the Ballast is switched off before connecting it
...
- Insert the connector of the lamphead (male) into the ballast output connector (female)
...
- Plug the Ballast into the Portable Power block
...
- Connect the power plug of the ballast to the Portable Power Block
...
- Switch on the lamphead by switching the ON/OFF switch to the “ON” position
...
- Switch on the ARRI ballast with the White Circuit breaker 25A.
...
- Press the round ON/OFF switch so the lamp head illuminates.
- The switch on the lamphead is for emergency use only.
...
- Use the ballast switch for switching the lamp on and off
...
- Check cables for tripping risk and secure with tape or cable covers where required.
...
- Switch off the light before moving the stand or adjusting the height.
- Be careful of Ultra Violet radiation
- Be careful, the lights and barn doors will get HOT.
- Attach the filters and diffusion lens as required
...
- NEVER look directly into the light source. This may lead to a health or safety issue on Set.