Power on procedure for the lighting system

• Turn on the Lighting Laptop
• Open up the Vista program
• Once the program is loaded with your show, turn on the dimmers
• Dimmers are located near the wall outside the bio box door.
• Turn on all 3 phase outlets. The 3 phase switches are under the plastic cover, lift that up to turn it on.
• Now turn on the G.P.O. switches on the left of the dimmers. You should only ever need to turn the bank of switches on left hand side. These power the LED and intelligent lights.
• Turn the house light control panel to “0” so Vista can control the house lights
• Now go back to the desk and run the show.

Power down procedure for the lighting system

• Turn the house light control panel to “100”
• Release all lights from the vista program
• Turn of the GPO power to turn of all LED lights
• Turn of the 3 phase power, you can just press the square button at the top
• Shut down the Vista program
• Close the laptop
• Turn of the bio box lights
• Have a nice day