Follow this procedure for the safe and correct use of the Jands 4PAK-D four channel controller/dimmer.

Place the 4Pak-D on a flat stable surface. Ensure the area around all chassis vents in clear.
Set all fader levels to zero.
Plug lights into the four output sockets. The total and individual channel loadings should not exceed the specified maximum – check with the Production Coordinator before use.
Fully uncoil the power lead and plug it in. The power plug needs to remain accessible during use.
Switch on the front panel circuit breaker. Do not use the breaker to turn the unit on/off.
Switch on the power at the wall.
Operate the 4Pak-D following the methods in the User Guide.
Follow usual safety procedures for working with lights and electrical devices.
After use, switch off the power at the wall. Do not use the breaker to turn the unit on/off.

It is normal for the 4Pak-D to get hot during use, especially near the rear vent holes. Ensure the vent holes are not obstructed. The unit will shut down if it overheats.

Browser not supported