Power-up and power-down procedure
- Karen Cook (Unlicensed)
- Stephen Carr (Unlicensed)
Power-up procedure
- Turn on desk power at the wall
- Turn on front of house speakers with the IR remote
Power-down procedure
- Turn off front of house speakers
- Turn off desk and rack power at the wall
Desk info
- Mute all unused channels
QLab Set up
How to Use the X32 (and QLab)
On:
GPO for the desk.
On switch for the back of desk.
GPO and On switches for amps.
To turn off just do this in the reverse order.
When Starting a New QLab file:
Open “New From Qlab” → X32 Base (this bypasses all the work).
Or if you want to do the work:
Click on the cog at the bottom right.
Click on Audio.
Audio Patch 2 → X-USB.
House Mic:
This mic also leads to the back-stage speaker.
CH1-16 → CH01 (House Mic) →Unmute → Set fader to what you want.
MATRIX 1-6, MAIN C → M/C → Unmute → Set fader to 0db.
Controlling the House Mic with QLab:
Click on the cog at the bottom right.
Click on OSC.
Patch 2 → IP Adress: 169.254.245.78 → Port: 10023 (done)
OSC cue → Settings → Destination: 2 (whatever you have named it).
Message Type: Custom OSC Message.
On: /ch/01/mix 1
Off: /ch/01/mix 0
(There is a PDF on the computer about controlling the X32 via OSC commands)
Main Left and Right Speakers:
AUX IN/USB, FX RETURNS → Aux 1 and Aux 2→ Unmute → Set faders to 0db.
Bring up Main fader to 0db.
You can control the levels in QLab faders 1 and 2.
Back Left and Right Speakers:
In QLab: Device and levels → Cross Points → 3,1 = 0, 4,2 = 0 (these are the faders that control the back speakers).
AUX IN/USB, FX RETURNS → Aux 3 and Aux 4→ Unmute → Set faders to 0db.
BUS 1-8 → Bus 1 → Unmute → Set fader to 0db.
MATRIX 1-6, MAIN C → Mtx 1 → Unmute → Set fader to 0db (this fader works independently to the Main fader and is unaffected by it).