Driver drill (battery powered)

Owned by Karen Cook (Unlicensed)
Last updated: Oct 06, 2015
2 min read

Follow this procedure for the safe use of a driver drill:

  • Ensure you are familiar with the safety guidelines for the driver drill.
  • Visually inspect the driver drill to make sure it is in good, clean condition.
  • Select the correct driver or drill bit for the job. Remove the battery before changing the bit. Turn the sleeve anticlockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck. Ensure the bit is inserted straight. Reinsert the battery pack.
  • Adjust the torque level and speed to the proper level for your work.

Screwdriver use:

  • Ensure the driver is set to the correct direction of rotation. Clockwise rotation inserts screws, anticlockwise rotation removes screws.
  • When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece.
  • Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. This method is the same whether inserting or removing screws.
  • If the bit is not properly connecting with the screw head, stop immediately. Continuing will damage the screw head and make it impossible to remove.
  • Do not touch the workpiece or screws immediately after use – they can get very hot.

Drill use:

  • Ensure the drill is set to the correct direction of rotation. Always drill with a clockwise rotation.
  • Place the point of the drill bit against the surface and apply pressure to the tool. Start the tool slowly and then increase the speed gradually.
  • For large holes, start with a small guide hole and increase the bit size gradually.
  • Do not touch the workpiece or bit immediately after use – they can get very hot.

 

Charge any flat batteries immediately. Do not leave batteries in the charger once fully charged.

If someone is bracing a surface (for example, a flat) from the other side, ensure all parts of their body are kept well clear from the drill bit or screw. Clearly communicate where each hole/screw will be placed and when.