Jands 4Pak-D

Follow this procedure for the safe and correct use of the Jands 4PAK-D four channel controller/dimmer.

• Place the 4Pak-D on a flat stable surface. Ensure the area around all chassis vents in clear.
• Set all fader levels to zero.
• Plug lights into the four output sockets. The total and individual channel loadings should not exceed the specified maximum – check with the Production Coordinator before use.
• Fully uncoil the power lead and plug it in. The power plug needs to remain accessible during use.
• Switch on the front panel circuit breaker. Do not use the breaker to turn the unit on/off.
• Switch on the power at the wall.
• Operate the 4Pak-D following the methods in the User Guide.
• Follow usual safety procedures for working with lights and electrical devices.
• After use, switch off the power at the wall. Do not use the breaker to turn the unit on/off.

It is normal for the 4Pak-D to get hot during use, especially near the rear vent holes. Ensure the vent holes are not obstructed. The unit will shut down if it overheats.